Futurelight DJ-LED CF-100 LED Effect-Projector Mode D'emploi page 26

Note:
After switching on, the DJ-LED CF-100 will automatically detect whether DMX 512 data is received or not. If
the data is received, the display will show "A.001" with the actually set address. If there is no data received
at the DMX-input, the display will show "A001".
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the DJ-LED
CF-100.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
DMX-protocol
Control-channel 1 - Gobos
Decimal Hexad. Percentage S/F
0 7 00 07 0% 3%
8 15 08 0F 3% 6%
16 23 10 17 6% 9%
24 31 18 1F 9% 12%
32 39 20 27 13% 15%
40 47 28 2F 16% 18%
48 55 30 37 19% 22%
56 63 38 3F 22% 25%
64 71 40 47 25% 28%
72 79 48 4F 28% 31%
80 87 50 57 31% 34%
88 95 58 5F 35% 37%
96 103 60 67 38% 40%
104 111 68 6F 41% 44%
112 119 70 77 44% 47%
120 127 78 7F 47% 50%
128 143 80 8F 50% 56%
144 159 90 9F 56% 62%
160 175 A0 AF 63% 69%
176 191 B0 BF 69% 75%
192 207 C0 CF 75% 81%
208 223 D0 DF 82% 87%
224 239 E0 EF 88% 94%
240 255 F0 FF 94% 100%
Control-channel 2 - Gobo rotation
Decimal Hexad. Percentage S/F
0 127 00 7F 0% 50%
128 255 80 FF 50% 100%
Control-channel 3 - Strobe
Decimal Hexad. Percentage S/F
0 7 00 07 0% 3%
8 247 08 F7 3% 97%
248 255 F8 FF 97% 100%
S Gobo 1
S Gobo 2
S Gobo 3
S Gobo 4
S Gobo 5
S Gobo 6
S Gobo 7
S Gobo 8
S Gobo 9
S Gobo 10
S Gobo 11
S Gobo 12
S Gobo 13
S Gobo 14
S Gobo 15
S Gobo 16
S Rot. gobo 1
S Rot. gobo 2
S Rot. gobo 3
S Rot. gobo 4
S Rot. gobo 5
S Rot. gobo 6
S Rot. gobo 7
S Rot. gobo 8
F Forwards gobo rotation with decreasing speed
F Backwards gobo rotation with increasing speed
S Closed
F Strobe-effect with increasing speed
S Open
26/52
Feature
Feature
Feature
51837505_V_1_0.DOC