Bort BSS-1215-Aqua Mode D'emploi page 4

• Store idle power tools out of the reach of children and do
not allow persons unfamiliar with the power tool or these
instructions to operate the power tool . Power tools are
dangerous in the hands of untrained users .
• Maintain power tools . Check for misalignment or binding
of moving parts, breakage of parts and any other condi-
tion that may affect the power tool's operation . If dam-
aged, have the power tool repaired before use . Many
accidents are caused by poorly maintained power tools .
• Keep cutting tools sharp and clean . Properly maintained
cutting tools with sharp cutting edges are less likely to
bind and are easier to control .
• Use the power tool, accessories and tool bits etc . in ac-
cordance with these instructions, taking into account the
working conditions and the work to be performed . Use
of the power tool for operations different from those in-
tended could result in a hazardous situation .
Service
Have your power tool serviced by a qualified repair person
using only identical replacement parts . This will ensure that
the safety of the power tool is maintained .
VACUUM CLEANER MAY NOT BE USED FOR:
• cleaning persons or animals
• vacuuming up:
– hazardous, sharp-edged, hot or red hot substances .
– highly flammable or explosive substances and gases
– ash, soot from tiled stoves and central heating systems
– toner dust from printers and copiers .
• Keep suction away from your head when using the
handle, nozzles or pipe .
=> Risk of injury .
• Stand the appliance on a firm, secure surface when
vacuuming .
• When vacuuming stairs, the appliance must always be
lower down than you .
• In the following cases, stop using the appliance
immediately and contact the after-sales service:
– if the mains connection cable is damaged .
– if you have accidentally vacuumed up some liquid or
liquid has entered the inside of the appliance
– if the appliance has been dropped .
• Do not use the power cord to carry the vacuum cleaner .
• Fully extend the power cord when using the vacuum
cleaner continuously for several hours .
• When disconnecting the appliance from the mains, pull
on the plug, not the power cord .
• Do not pull the power cord around sharp corners or
allow it to become trapped .
• Unplug the power cord from the mains before carrying
out any work on the vacuum cleaner or its accessories .
• Do not use the vacuum cleaner if it is damaged . Unplug
the power cord from the mains if a fault is detected .
• For safety reasons, only authorised after-sales service
personnel are permitted to carry out repairs and fit
replacement parts to the vacuum cleaner .
• Protect the vacuum cleaner from outside weather
conditions, moisture and sources of heat .
• The vacuum cleaner is not suitable for use on building
sites .
=> Vacuuming up building rubble could damage the
appliance .
• Switch off the appliance when it is not in use .
• At the end of its life, the appliance should be rendered
unusable, then disposed of in an appropriate manner .
• Plastic bags and films must be kept out of the reach of
children before disposal (risk of suffocation) .
• Do not pour any flammable substances or substances
containing alcohol onto the filters (filter bag, motor
protective filter, exhaust filter, etc .) .
CAUTION
1 . The vacuum has multi functions, please read the manual
carefully before operating and select suitable accessories
for different cleaning purposes .
2 . Don't leave when the vacuum is running . Please power
off and take off the plug after the cleaning .
3 . Home use and indoor use only .
4 . The vacuum is not suitable for children .
5 . Only supplied accessories can be used .
6 . Any damage, please contact aftersales office for profes-
sional service .
7 . Check the suction hose if any blockage before operation .
8 . Please power off the vacuum immediately if any acci-
dents .
WATER FILTER VACUUM CLEANER
INSTRUCTION
Caution
1 . Add the water to the tank over MIN line before using .
Clean the tank when the dust to the MAX line .
2 . Stop the vacuum immediately if any water sprays out .
Check if too much water is collected in . Clean the water
tank and floater assembly .
INSTRUCTION:
1 . Take out top vacuum part .
2 . Take out the water cover and add the water over the MIN
line but below the MAX line .
4