N
Before using the Remote Control Unit
A battery is .already installed in the remote control
unit. Remove the insulation film before using.
Battery Replacement
1. Remove the battery holder.
Grip the holder at position B and pull it out to re¬
move the battery by pushing position A in the di¬
rection shown by the arrow.
2. Replace the battery.
Set the new battery correctly with its ( + ) side fac¬
ing up as shown in the figure.
3. Insert the battery holder.
Push the battery holder back into its original posi¬
tion.
Lithium battery
Position B
Battery Notes
Remove and dispose of an old battery immediately.
Battery Information:
• Battery type: Panasonic lithium battery (CR2025)
• Battery life: Approximately 6 months with normal use (at room temperature)
Battery holder
Position A
Caution:
Improper use of the battery may cause overheating, an explosion or ignition, resulting in injury
or a fire. Battery leakage may damage the unit.
H
• Do not disassemble or short the battery. Do not throw a battery into a fire.
• Keep batteries out of the reach of children to avoid the risk of accidents.
Remote Control Unit
POWER Button
Used to turn the power
source ON and OFF.
ASPECT Button
Used to display, select
and determine the
ASPECT(display size).
(* Page 12)
VOLUME Control Buttons
Used to adjust the volume
level of the built-in speaker
(* Page 11)
MODE Button
Used to change the
input source
BRIGHTNESS Control Buttons
When AUTOMATIC is selected
in the DIMMER SELECT:
Used to set to the best visibility
brightness level for night time
(• Page 14)
When MANUAL is selected in
the DIMMER SELECT:
Used to adjust the screen
brightness
Page 17)
CY-VM1500EX
9