Panasonic CY-VM1500EX Manuel D'utilisation page 27

□ Before Installation
The metal fitting body cannot be installed in all
models of motor vehicles. Be sure to confirm
first with the sales outlet that it can be installed
in your vehicle.
After setting up the metal fitting body, be aware
that it is necessary to make a hole at an instal¬
lation position inside the car and stabilize the
metal fitting body with a screw to prevent it
from falling over.
□ Required Tools
You'll need the following:
12 V DC ELECTRICAL SIDE-CUT
TEST BULB TAPE PLIERS
20
WARNING
• Do not install the monitor in a location which
obstructs driving, visibility or which is prohib¬
ited by applicable laws and regulations.
If the monitor is installed in a location which
obstructs forward visibility or operation of the
air bag or other safety equipments or which
interferes with operation of the vehicle, it
may cause an accident.
• Never use bolts or nuts from the vehicle's
safety devices for installation.
If bolts or nuts from the steering wheel,
brakes or other safety devices are used for
installation of the monitor, it may cause an
accident.
• Attach the wires correctly.
If the wiring is not correctly performed, it
may cause a fire or an accident. In particu¬
lar, be sure to run and secure the lead wire
so that it does not get tangled with a screw
or the moving portion of a seat rail.
• Use with 12 volt DC negative ground vehi¬
cle. This unit is only for use with a 12 volt
DC negative ground vehicle. It cannot be
used in large trucks or diesel vehicles which
are 24 volt DC vehicle. If it is used in the
wrong type of vehicle, it may cause a fire or
an accident.
CAUTION
• Use the specified fuse.
Be sure to always use the specified fuse: If a
fuse other than the specified fuse is used, it
may cause a fire or an accident.
• Do not damage the cord by pinching or
pulling it.
Do not pull or damage the cord. If the cord is
not treated properly, it will short out or be
severed and may cause a fire or an acci¬
dent.
□ Identify All Leads
The first step in installation is to identify all the
vehicle wires you'll use when hooking up your
LCD monitor.
As you identify each wire, we suggest that you
label it using masking tape and a permanent
marker. This will help avoid confusion when
making connections later.
Note:
Do not connect the power connector to
controller unit until you have made all connec¬
tions. If there are no plastic caps on the hook¬
ing wires, insulate all exposed leads with
electrical tape until you are ready to use them.
Identify the leads in the following order.
Power Lead
If your vehicle has a radio or is pre-wired for
one:
Cut the connector wires one at a time from the
plug (leaving the leads as long as possible) so
that you can work with individual leads.
Turn on the ignition to the accessory position,
and ground one lead of the test bulb to the
chassis. Touch the other lead of the test bulb
to each of the exposed wires from the radio
connector plug. Touch one wire at a time until
you find the outlet that causes the test bulb to
light.
Now turn the ignition off and then on. If the
bulb also turns off and on, that outlet is the ve¬
hicle poyver lead.
If your vehicle is not wired for an audio unit:
Go to the fuse block and find the fuse port for
accessory (ACC), or ignition (IGN).
CYVM1500EX
27