Panasonic CY-VM1500EX Manuel D'utilisation page 28

Installation Guide
(continued)
21
□ Connect All Leads
Now that you have identified all the wires in the
vehicle, you're ready to begin connecting them
to the controller unit wires. The connection dia¬
gram (■• Page 31) shows the proper connec¬
tions and color coding of the leads.
We strongly recommend that you test the unit
before making a final installation.
You can set the unit on the floor and make
temporary connections to test the unit. Use
electrical tape to cover all exposed wires.
Important:
Connect the red power lead last,
after you have made and insulated all other
connections.
Ground
Connect the black ground lead of the power
connector to the metal vehicle chassis.
Power
Connect the red power lead to the correct vehi¬
cle radio wire or to the appropriate fuse port on
the fuse block.
If the LCD monitor functions properly with all
these connections made, disconnect the wires
and proceed to the final installation.
□ Final Installation
Lead Connections
Connect all wires, making sure that each con¬
nection is insulated and secure. Bundle all
loose wires and fasten them with tape so they
won't fall down later.
Congratulations! After making a few final
checks, you're ready to enjoy your new auto
LCD monitor.
□ Final Checks
1. Make sure that all wires are properly con¬
nected and insulated.
2. Turn on the ignition to check the unit for
proper operation.
If you have difficulties, consult your nearest au¬
thorized professional installer for assistance.
28
CY-VM1500EX