PNI Safe House PG600 Manuel Utilisateur page 6

2. Connecting to the WiFi network. Method # 2
If you cannot add the alarm system by the method above, follow the steps below.
• Open the application, press "+" in the upper right corner to add devices → select
"Security & Sensor" → "Alarm Wi-Fi".
• Press "AP Mode" in the upper right corner.
• Power the central unit (siren) and turn it on by moving the button to the ON position.
Using a sharp object, reset the device. The red area of the device blinks to indicate
that it is in pairing mode.
• Confirm in the application if the device is blinking.
• From the next interface, select the WiFi network, enter the password and press
"Confirm"
• Connect your phone to the alarm system hotspot. Click "Go to Connect"
• From the list displayed select "SmartLife_XXXX" to connect.
• Wait for the alarm device to connect.
6