Allmatic MOVEO 700 24V Mode D'emploi page 13

GATE POSITIONING IN RELATION TO HORIZONTAL PLANE
For special installations request information from Allmatic or use larger geared motors.
RELEASE
To move the gate manually it is necessary to release the gearmotor inserting the key, turning it for 90° and open the lever (Fig. 14).
In order to carry out the manual operation of the gate leaf the followings must be checked:
- That the gate is endowed with appropriate handles;
- That these appropriate handles are placed so to avoid safety risks for the gearmotor;
- That the physical effort necessary to move the gate leaf should not be higher than 225 N, for doors/gates for private dwellings, and, 390N
for doors/gates for commercial and industrial sites ( values indicated in 5.3.5 of the EN 12453 norm).
DISPOSAL OF THE PRODUCT
This product is an integral part of the automation, and therefore, they must be disposed of together. As for the installation operations, at the end of the
life of this product, the dismantling operations must be performed by qualified personnel. This product is made from different types of materials: some
can be recycled, others must be disposed of. Please inform yourselves on the recycling or disposal systems provided for by the laws in force in your area,
for this category of product.
CAUTION! – some parts of the product can contain polluting or dangerous substances which, if dispersed in the environment, may cause
serious harm to the environment and human health.
As indicated by the symbol at the side, it is forbidden to throw this product into domestic refuse. Therefore, follow the "separated collection"
instructions for disposal, according to the methods provided for by local regulations in force, or redeliver the product to the retailer at the
moment of purchase of a new, equivalent product.
CAUTION! – the regulations in force at local level may envisage heavy sanctions in case of abusive disposal of this product.
WARRANTY
In compliance with legislation, the manufacturer's guarantee is valid from the date stamped on the product and is restricted to the repair or free
replacement of the parts accepted by the manufacturer as being defective due to poor quality materials or manufacturing defects. The guarantee
does not cover damage or defects caused by external agents, faulty maintenance, overloading, natural wear and tear, choice of incorrect product,
assembly errors, or any other cause not imputable to the manufacturer. Products that have been misused will not be guaranteed or repaired. Printed
specifications are only indicative. The manufacturer does not accept any responsibility for range reductions or malfunctions caused by environmental
interference. The manufacturer's responsibility for damage caused to persons resulting from accidents of any nature caused by our defective
products, are only those responsibilities that come under Italian law.
6-1624870 rev.5
Fig. 13
OK
13/09/2022
Fig. 13
NO
Fig. 14
13 / 40