Publicité
Les langues disponibles
Les langues disponibles
Cleaning
The tool may be cleaned most effectively with compressed dry air.
WARNING
clean and free of foreign matter. Do not attempt to clean by inserting pointed objects through
openings.
WARNING
ammonia and household detergents that contain ammonia.
Storage
Store the tool indoors in a place that is inaccessible to children. Keep away from corrosive
agents.
TROUBLESHOOTING
Problem
Tool will not start.
Bit cannot be installed.
Motor overheating
WORKLIGHT flashes
rapidly.
WORKLIGHT flashes
slowly.
20
Always wear safety goggles when cleaning tools with compressed air .
The guard system, ventilation openings, and switch levers must be kept
Certain cleaning agents and solvents damage plastic parts . Some of
these are: gasoline, carbon tetrachloride, chlorinated cleaning solvents,
Cause
1. Battery pack is depleted.
2. Battery pack is not installed
properly.
3. Burned out switch.
1. Chuck is not released.
2. Bit does not fit the chuck.
Ventilation slots are obstructed.
The tool has stopped working to
protect internal electronics.
The battery charge is very low.
Remedy
1. Charge the battery.
2. Confirm that the battery is
locked and secured to the
tool.
3. Have the switch replaced
by an Authorized SKIL
Service Center or Service
Station.
1. Release the chuck.
2. Use an appropriate bit or
use a suitable adaptor.
Clean and clear the
ventilation slots. Do not cover
the slots with hand during
operation.
Release the trigger switch,
wait for the tool to cool down,
then and start the tool again.
Charge the battery.
Publicité
