Publicité
Les langues disponibles
Les langues disponibles
Integrated Bit Clip (Fig. 10)
Your tool is equipped with an integrated bit clip
located on the back of the tool. Use the bit clip
to conveniently store hex bits.
Strap Fixing (Fig. 10)
Strap fixing is provided to attach a wrist strap (not included) in order to reduce the chances of
dropping your tool. Wrap the strap around your hand when carrying the tool.
Drill Bits
Always inspect drill bits for excessive wear. Use only bits that are sharp and in good condition.
Twist Bits: Available with straight and reduced shanks for wood and light-duty metal drilling.
High-speed bits cut faster and last longer when drilling hard materials.
Carbide-Tipped Bits: Used for drilling stone, concrete, plaster, cement, and other unusually
hard nonmetal materials. Use continuous, heavy feed pressure when using carbide-tipped bits.
Drilling (Fig. 11)
WARNING
with side shields during power tool
operation or when blowing dust . If the
operation is dusty, also wear a dust mask .
a. Check that the direction-of-rotation selector
is at the correct setting (forward or reverse).
b. Secure the material to be drilled in a vise or
with clamps to keep it from turning as the
drill bit rotates.
c. Hold the drill firmly and place the bit at the
point to be drilled.
d. Squeeze the variable-speed trigger switch to
start the drill.
e. Move the drill bit into the workpiece, applying
only enough pressure to keep the bit "biting". Do not force the drill or apply side pressure to
elongate a hole. Let the tool do the work.
f. When drilling hard, smooth surfaces, first use a center punch to mark the desired location of
the hole. This will prevent the drill bit from slipping off-center as the hole is started.
g. When drilling metals, use light oil on the drill bit to keep it from overheating. The oil will
prolong the life of the bit and increase the drilling action.
16
Always wear safety
goggles or safety glasses
Fig . 10
Bit Clip
Fig . 11
Strap Fixing
Publicité
