Publicité
Les langues disponibles
Les langues disponibles
Installation
9.1 Installing the appliance
u If already in place, pull the plinth panel forwards.
u Detach the connecting cable from the rear of the
appliance, removing the cable holder at the same
time because otherwise there will be vibratory noise!
u Lay the connecting cable with
the help of a string in such a
way that the appliance can be
easily connected after fitting.
NOTICE
Risk of harm to flooring susceptible to damage!
u Under each adjustable foot at the side, place a cardboard
strip approx. 100 mm x 600 mm. Cut the strips out of the
packaging. For recess heights of less than 826 mm, use
strips of a firm but thin material.
u After pushing the appliance in, remove the strips again.
Top fixing
Fig. 17
u Insert the bracket into the holder on the top of the unit
and bend towards the front.
u Slide the unit into the recess and level, see Levelling the
appliance.
Side fixing:
38
Fig. 15
Fig. 18
u Bend both brackets at one end before installation. Insert
the straight edge into the holder on the top of the unit
and bend towards the front.
u Slide the unit into the recess and level, see Levelling the
appliance.
Levelling the appliance
Fig. 16
u Unscrew the rear adjusting feet using a screwdriver and
undo the front adjusting feet using a no. 8 Allen key alter‐
nately until the unit sits just under the worktop.
u Use a spirit level to level the unit.
w The gap from the front edge of the cabinet wall to the
appliance should be 41,5 mm on both sides.
w Should there be no unit side wall, align it with the work
top.
For units with door stop components (knobs, sealing
lips etc.):
u Deduct the extra dimension (depth of the door stop
components) from the 41.5 mm depth of insertion.
u Unscrew the rear adjusting feet using a screwdriver and
undo the front adjusting feet using a no. 8 Allen key (if
the adjusting feet are retracted) or a screwdriver (if the
adjusting feet are extended) alternately as far as they
will go. The maximum adjustment range is 60 mm.
w The appliance is aligned upright.
w The appliance is slightly braced between the floor and
the work top.
* Depending on model and options
Fig. 19
Publicité
