Publicité
Les langues disponibles
Les langues disponibles
96
GRASS CUTTING IS POOR
POSSIBLE FAULT
Blades dull or damaged
Cutting too much in one pass.
Cutting height not suitable.
NOTE: If you are unable to resolve the problem, please contact the Official Technical Service.
TRANSPORTATION AND STORAGE
•
Allow the equipment to cool completely before transporting or storing.
•
Avoid a location exposed to sunlight when placing the machine in a vehicle. If the machine is left in a locked
vehicle for many hours, high temperatures inside the vehicle can cause the fuel to evaporate and cause a possible
explosion.
•
To prevent fuel loss during transport, the product should be secured in its normal operating position and with
the fuel cap closed.
•
Always store the product in a clean, safe, dry place with temperatures between 0º and 45ºC.
•
The equipment is not weatherproof and should not be stored in direct sunlight, high temperatures or in damp
places.
•
Never store the equipment in places where flammable materials, combustible gases or liquids, etc. are present.
•
To reduce the risk of fire, keep the machine clean by removing traces of material, oil and grease.
•
For long periods of storage, store the machine without fuel. The stored fuels must be stabilized with a stabilizer.
•
Store the machine out of the reach of children.
LONG-TERM STORAGE
Follow general storage procedures, and also:
•
Drain the fuel system. It is recommended to keep the tank as empty as possible before draining.
1.
Unscrew (to the left) the drain plug from the carburetor. Use a suitable container to collect the drained fuel
and allow the fuel to drain. Store the drained fuel in an airtight container.
2.
Screw the carburetor drain plug back on (turning clockwise) and tighten.
•
Remove the spark plug and put 30ml of clean engine oil into the cylinder. Pull the starter rope slowly to distribute
the oil. Replace the spark plug.
•
Cover the equipment to protect it from dust and dirt.
Sharpen or replace cutting blades.
Adjust the cutting height and rate of mowing to reduce load on the engine.
For tall or very thick grass, cut in several passes. Do not attempt to cut beyond
the capacity of the machine.
Adjust cutting height as required.
SOLUTION
Publicité
