Kohler K-1914 Guide D'installation page 33

Confirm Proper Airjet Operation (cont.)
Observe that the blower motor starts at a midrange speed.
Observe that air is blowing through all of the airjets.
Press the up button on the user keypad.
Verify that the air flow increases.
Press the down button on the user keypad.
Verify that the air flow decreases.
Press the On/Off button on the keypad to stop the blower motor.
Drain the Bath
Press the door switch and confirm that the drain valve opens. Open the footwell drain.
When the water level falls below the level sensors in the footwell, confirm the seal has deflated.
Squeeze the door handle and lower the door.
Confirm Manual Purge Operation
When the bath has drained, press the purge button once.
Observe that the blower motor starts at low speed and blows any residual water from the air
channels.
Observe that air comes out of the airjets.
Verify that pressing the purge button again stops the blower motor.
Press the purge button to restart the manual purge.
Observe that the blower motor stops automatically after about 2 minutes.
Confirm Automatic Purge Operation
Press the On/Off button.
Press the On/Off button again to turn off the blower. Note the time.
Observe that the blower motor starts in the purge cycle after about 30 minutes.
Observe that the blower motor stops automatically after about 2 minutes.
Kohler Co. 33 1128535-2-B