Kohler K-1914 Guide D'installation page 29

Adjust the Bath Door (cont.)
Make sure that no wires come in contact with any moving parts, particularly when the door moves
up and down. Sufficient clearance must be maintained to prevent damage to the wires.
Adjust the Latch Pin Alignment
Make sure the latch pins are centered in the strike plate on each side of the door when the door is
latched.
To center the latch pin, adjust the top bumper on the side the adjustment is needed until the
bumper contacts the roller assembly when the latch is centered in the strike plate.
Tighten the bumper nut to secure the bumper into position.
Adjust the Limit Switch
Make sure the limit switch is properly adjusted. If the limit switch is properly positioned, the strike
plate lightly contacts the boot. See the diagram labeled "Proper Adjustment" above.
If adjustment is needed, loosen the screw.
If the latch pin does come in contact with the strike plate, tilt the limit switch forward.
If the strike plate compresses the blue boot too far, tilt the limit switch back.
When correct alignment has been achieved, tighten the screw.
Complete the Adjustments
Dry fit the trim caps and test the door for smooth operation (not shown; for additional information
see "Install the Trim Caps and Access Panel").
Recheck the door movement, using one finger to move the door up and down.
When properly adjusted the door should move up and down using one finger.
Adjust the mounting bracket and/or pulley assemblies as needed.
Repeat until the door operates smoothly.
Kohler Co. 29 1128535-2-B