R&G CP0302 Instructions De Montage page 4

Page | 4
FITTING INSTRUCTIONS
Near side (left side as you sit on bike)

Remove the left hand side fairing (ensuring to disconnect the indicators).

Remove the engine/frame bolts in position arrowed in picture 1 (using 10mm allen key). The bolt
at the front is secured with a nut at the rear. (The button head bolt at the rear must be reused on
assembly). Use a 14mm spanner as shown in picture 2.

Slide one of the 10mm washers (item 4) onto the M10 hexagon headed bolt (item 3=120mm long)
so washer sits against head of the bolt as shown in picture 4.

Place the bolt with washer though the front hole (thick end) of the mounting block (item 7) and
through the spacer (item5) (ensure the widest end sits against the mounting block as shown in
picture 3).

Place the mounting block (item 7) in position as shown in picture 4.
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
PICTURE 3
PICTURE 5
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
R&G Racing
www.rg-racing.com Email:
PICTURE 4
PICTURE 6
info@rg-racing.com