Publicité
Les langues disponibles
Les langues disponibles
• ENGLISH •
MAINTENANCE
MAINTENANCE - Cleaning
The upholstery and seat belts can be cleaned using a clean cloth, warm water
and soap.
The plastic parts can be cleaned with mild soap and warm water.
⚠
Do not use harsh detergents such as solvents.
The car seat must not be used without the lining.
REMOVING THE CANOPY (fig. 22)
Removing the lining
Press the red release button and unhook the harness.
Remove the shoulder straps from the small seat, cover and chassis in plastic,
by pulling each shoulder strap, including buckle, through its corresponding slot.
Do not remove the shoulder straps from the loop of the harness adjuster strap.
Remove the belt following the instructions in the "How to remove the harness
buckle" paragraph and remove the buckle from the cover.
Pull out the cover from shell front.
To put the lining back on, follow the reverse procedure.
IMPORTANT! Make sure that it is correctly assembled, check that none of the
belts are twisted.
How to remove the harness buckle
• Unclip the buckle (press the red release button).
• Loosen the belts on the harness.
• Locate the metal ring attached to the belt under the child restraint.
• Rotate the metal ring and remove it through the shell and the padding.
How to replace the harness buckle
• Insert the metal ring and the crotch strap through the padding and the shell.
• The metal ring, fastened to the belt, must come out from the shell.
• Pull the centre buckle to check that the crotch strap is correctly secured.
How to remove the harness
• Unclip the harness buckle (press the red button).
• Unclip the shoulder straps from the belt-tightening device, located on the rear
of the backrest.
• Pull both belts through the shell and the lining and remove the chest protectors.
• Locate the metal ring attached to the belt under the child restraint.
• Rotate the metal ring and remove it through the shell and the padding.
39
Publicité
