PLACING YOUR CHILD IN THE CAR SEAT
USING THE BUCKLE
To release the buckle (fig. 1): Press the red button on the buckle to release the
shoulder straps and move them to the side.
To attach the buckle (fig. 2.1, fig. 2.2, fig. 2.3): Join together the two ends/ tabs
of the straps to form a single connector.
Insert the connector into the central buckle until you hear a click.
Make sure that the straps are not twisted.
Adjust the chest protectors to the
centre of the child's shoulders.
ADJUSTING THE SEAT BELT (HARNESS)
Loosening the straps (fig 3): Press the adjuster button on the front center of the
seat, and pull on both shoulder straps to loosen the harness.
Tightening the harness (fig. 4): Pull the harness adjustment strap so as to tighten
it properly against the body of the child. The harness is correctly tightened when
the gap between the harness and the child is no greater than the thickness of
your finger.
IMPORTANT! Pull the end of the adjuster strap outwards, not upwards or
downwards. During transport (especially when not in the car), the adjuster strap
must be placed in the belt compartment.
☞ Ensuring that your child is properly secured with the harness.
To ensure the safety of your child, check that......
•
The straps are adjusted correctly at the height of the child's shoulders.
•
The straps are not twisted.
•
The tabs are properly engaged in the harness buckle.
•
The straps are properly tightened, as the gap between the harness and the
child must not be greater than the thickness of your finger.
TO ADJUST THE HEADREST AND STRAPS
Loosening the straps (fig 5): Press the adjuster button on the front center of the
seat, and pull on both shoulder straps to loosen the harness.
To adjust the headrest and straps (fig.6. fig.7): Pull the harness adjustment lever
upwards and at the same time slide the adjuster upwards or downwards until the
chest straps are at the correct height.
Release the adjustment lever to lock the adjuster in the new position.
• ENGLISH •
USING THE CAR SEAT
34