Installing And Connecting; Use; First Use; Fuel - Dovre 40CBS Installation Et Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 50
8. Use the supplied stove sealant to seal the con-
nection collar and the cover to the appliance.
Connecting to the top
You need a special connection collar to connect on
the upper side. This is not supplied with the appli-
ance.
1. Remove one of the rectangular covers from the
upper side of the appliance.
2. Install the special connection collar on the opening
created.
3. Use the stove sealant supplied for sealing the con-
nection collar and the appliance.
Connecting via the attachment 5T
The attachment 5T increases the surface of the stove
that exchanges heat, thereby increasing efficiency.
Subject to change because of technical improvements
When using the attachment 5T that is sold separately,
you are able to make a side connection and an upper
connection via the attachment.
1. Remove the rectangular cover from the upper side
of the appliance.
2. Install the attachment 5T on the openings created.
3. Use the supplied stove sealant for sealing the
attachment and the appliance.
4. Follow the further instructions in the paragraph
"Connecting on the side or to the rear" to make the
flue gas opening and to install the supplied con-
nection collar.

Installing and connecting

1. Position the stove in the correct place, and make
sure it is level.
2. Connect the stove to the fuel hermetically.
3. Hook the ash tray under the bottom plate under the
door.
4. Re-position all removed parts in the correct places
in the stove.
Never use the appliance without the cast-iron
inner plates.
The stove is now ready for use.

Use

First use

When you use the appliance for the first time, make
an intense fire and keep it going for a good few hours.
This will cure the heat-resistant paint finish. This may
result in some smoke and odours. You could open win-
dows and doors for a while in the area in which the
appliance is located.

Fuel

This appliance is only suitable for burning natural
wood; sawn and chopped wood that is sufficiently dry.
Do not use other fuels, as they can cause serious
damage to the appliance.
11

Publicité

Table des Matières
loading

Table des Matières