Installation instructions
EN
for the specialist company
● Open combustion chamber!
● Before lighting, check that no flammable objects have been
placed on the stove!
● Open the combustion air slide fully!
● Place a small amount of firewood on top of the kindling and light
it (kindling cubes and dry, small kindling wood)!
● Close the combustion chamber door so that the kindling can
burn well!
● Only operate the stove with the combustion chamber door
closed!
● As soon as there are glowing embers, add the appropria-
te amount of fuel to meet the heat requirement see chapter
„Heating").
● Watch out for small children and do not leave small children unat-
tended near the device while it is in operation and hot!
Warning! Serious personal injury and property damage!
(burns/fire hazard)
The surfaces of the device, especially the glass panes of the
combustion chamber, become very hot.
● Keep a safe distance from these surfaces!
● Do not hang or lean any objects on the heater (e.g. for dry-
ing or heating)!
● Only operate the stove with the combustion chamber door
closed!
● Do not operate the stove during prolonged absences!
● Watch out for small children and do not leave small children
unattended near the stove while it is in operation and hot!
● Do not remove hot ash!
● Store ashes only in fireproof, non-combustible containers!
Warning! Serious personal injury and property damage!
(Danger of suffocation, fire or explosion)
● Do not use the stove under any circumstances if you noti-
ce malfunctions in operation, in the regulation and control
system, leaks in the air/flue gas duct or damage to the door
seals!
● Contact a specialist company!
Note! No chimney draught!
When lighting the fireplace, it may happen that the firewood
cannot be lit if there is no chimney draught in the chimney
at the same time as the ventilation system. Briefly opening a
window in the room where the stove is installed can help with
this.
We reserve the right to make technical changes
Fig. 3.3
Lighting the stove
OSORNO L L/R
39