Dometic Ace AIR Pro Notice D'utilisation page 14

Setting up the awning tent
!
CAUTION! Risk of injury and mate-
rial damage
• Do not use any type of compressor
designed to inflate car tires.
• Only inflate the air poles into the green
zone of the pressure gauge of the sup-
plied hand pump (9 psi/0.62 bar).
A
NOTICE! Material damage
• Do not open or close the zippers by
force.
• If a wind-out awning is used to attach
the awning tent, support the wind-out
awning while working to avoid putting
too much stress on it. After attaching
the awning tent, rewind the wind-out
awning fully back into its housing.
I
NOTE
• The awning tent comes with heavy
duty pegs. These will be suitable for
many sites but for some types of
ground special pegs will be needed.
Ask your dealer.
• Drive the pegs at a 45° angle away
from the awning tent into the ground.
• Peg each guy line in-line with the seam
it starts from.
Keep the following tips in mind while setting up the
awning tent:
• The figures provide a general overview of the
set-up. The actual set-up will vary slightly based
on the model of awning tent.
• Get help. The set-up is easier with more people.
• After standing the awning tent upright, check
the corner pegs and re-peg if necessary. The
groundsheet on the inside should be taut and in
a rectangular shape.
• Peg the guy lines so that the awning tent is under
tension without distorting the shape.
• If available, attach the storm straps.
• Check the guy lines from time to time to ensure
adequate tension, if necessary use the runners to
adjust.
14
Set up the awning tent as follows:
1. To protect the awning tent from dirt and dam-
age, lay down a groundsheet or footprint
before unpacking.
2. Unpack the awning tent.
3. Separate and identify the different compo-
nents.
4. Proceed as shown to set up the awning tent
(fig. 3, page 5 to fig. l, page 9).
Only Ace AIR PRO 500 made before January 2022:
5. Inflate the additional air pole.
6. Fix the inflated air pole into place in the middle
back roof panel using the velcro fasteners.
You find the production data on the label next to
the fire regulation label inside the back of the
awning.
Dismantling the awning tent
A
NOTICE! Damage hazard
Do not use force when dismantling the
awning tent. Otherwise you might dam-
age any material.
1. Remove any dirt on the outside.
2. Close all window blinds or remove curtains.
3. Close all doors and openings.
4. If installed, push the canopy pole out of the
sleeve, do not pull.
5. Remove all lines and straps.
6. Remove all pegs between the corner pegs.
7. Open the valves on each pole.
8. Wait until most of the air has been expelled.
9. Remove the four corner pegs.
10. Fold/roll the awning tent towards the valves to
expel more air.
11. When deflated, roll the awning tent to fit into
the carry bag.
12. Ensure that all parts are clean before packing
them into the carry bag.
13. If the awning tent is wet or damp, dry fully as
soon as possible.
4445103255
EN