Gaggenau BS 470 612 Notice De Montage page 6

en-us
Before you begin
Before you begin
T ools and Parts Needed
B e f o r e y o u b e g i n
Philips head screwdriver
▯
1/8" drill bit and drill
▯
Measuring tape
▯
Parts Included
Combi-steam oven
▯
1 Torx screw
▯
Power Requirements
The outlet must be properly grounded in accordance with
all applicable codes.
Planning Notes
Door hinge not interchangeable.
Distance from furniture body to door front 1.85" (47 mm).
Pay attention to the front protrusion, possibly including
the door handle, for opening drawers at the sides.
When planning a corner solution, pay attention to the
door opening angle of at least 90°.
No other electrical appliance may be integrated into the
cupboard above this appliance.
Do not install the appliance version with the control panel
on the bottom above a dishwasher. Ascending steam from
the dishwasher can damage the appliance electronics.
6
All manuals and user guides at all-guides.com
Preparing Kitchen Units
P r e p a r i n g K i t c h e n U n i t s
resistant up to 195°F (90°C) and adjacent cabinets up to
160°F (70°C).
Connection box must be outside of the installation niche.
Perform cut-out work on the furniture before inserting the
appliance. Remove any shavings or the function of the
electrical components may be impaired.
Secure freestanding units to the wall using a standard
bracket.
Only fit the appliance up to a height that allows
accessories to be removed easily.
U nits into which ovens are to be fitted must be heat-