Gaggenau BS 470 612 Notice De Montage page 12

en-us
Preparing Kitchen Units
Align the door via the lateral screw (Torx 20). It might be
necessary to open and close the door.
Check the alignment and tighten both screws (Inbus
5 mm) again. Attach the cover cap again.
Notes
The device door is already aligned when the appliance
▯
is delivered. You do not normally need to align the
door.
The alignment of the appliance door can be adjusted
▯
at the hinge, in order to achieve a precise gap size.
The height of the door cannot be adjusted.
▯
12
All manuals and user guides at all-guides.com
Three wire connection
BO 450/451-610
1.
2.
3.
Attach flexible conduit to the junction box.
To facilitate serviceability, the flex conduit must not be
shortened and should be routed to allow for temporary
removal of the oven.
Means for disconnection must be incorporated in the
fixed wiring in accordance with the wiring rules.
Combination with an oven
Fit the Combi-steam oven first and then the oven.
For an installation depth of 21
water hoses and the connecting cable in the area of the
housing cut-out.
The rear of the BO 4.. ovens has a bevelled corner. Route
the Combi-steam oven's supply and drain water hoses
downwards to the connection points on the rear left in
the kitchen unit.
If the hoses are not routed in the corner on the rear left in
the kitchen unit, when installing the appliance over an
oven the kitchen unit's body must be pulled forward by at
least 1 \" (35 mm) and side paneling or a trim must be
inserted.
Connect red wire from oven to red electrical supply
wire (hot wire).
Connect black wire from oven to black electrical
supply wire (hot wire).
Connect yellow/green ground oven wire to bare
ground electrical supply wire.
/ " (550 mm), position the
5
8