Costway FP10269US Mode D'emploi page 10

5.4.2.Operation mode
The unit has five operation modes: cool, dry, fan, heat and sleep.
The unit working temperature under cooling mode is 16°C-35°C
(61°F~95°F), under heating mode is 5°C-27°C(41°F~81°F).
A. Cooling your room
Select the cool mode to lower the temperature in your room.
Press MODE button repeatedly until the LED of COOL operation lights
up.
Press Up/Down button to adjust the temperature which is displayed on
the screen. The temperature can be set between 16°C and 32°C
(61°F~90°F).
Press SPEED button repeatedly until the desired fan speed indicator
lights up.
To control the direction of the air flow horizontally, please press the
SWING button on.
Note: The air conditioner stops if the room temperature is lower than
selected temperature.
B. Heating your room(Optional for Heating Function Unit only)
Press MODE button repeatedly until the LED of HEAT operation lights up.
Press ADD/MINUS button to set the temperature higher than the room
temperature. The fan speed can also be set.
Note: The drainage hose should be attached to the unit for continuous
operating.
C. Ventilating your room
Press MODE button repeatedly until the LED of FAN operation lights up.
In ventilation mode, the room air is circulated, but not cooled.
Press SPEED button repeatedly to select the fan speed as desired.
D. Drying your room
Press MODE button on the control panel or remote control, the LED of DRY
operation lights up. The fan speed is unable to select. User should connect the hose
to the drain outlet at the bottom of the unit.
Note: In this mode, the fan speed switches over to low speed and the temperature
cannot be selected.
18
E.Sleep mode
The sleep mode can be activated when in cool mode and heat mode.
• In cool mode:
After 1 hour the preset temperature is increased by 1°C(2°F), after another
hour the preset temperature will again be increased by 1°C(2°F).
• In heat mode(Optional for Heating Function Unit only) :
After 1 hour the preset temperature is decreased by 1°C(2°F), after another
hour the preset temperature will again be decreased by 1°C(2F).
Then the temperature is kept constant for 10 hours. And all the indicators dim to
dark. The fan speed may switch over to low speed for silent operating and
cannot be selected.
5.4.3.TIMER SETTING(1 hour-24 hours):
The timer has two ways of operation:
To turn off Press Timer key to turn on
(When power on) the timer function.
To turn on Press Timer key to turn on
(When power off) the timer function.
Press Up /Down repeatedly until the LED shows "00".
Cancel timer
Note: when press POWER, the unit will also exit the timer setting.
5.4.4.Automatic Defrost
At low room temperatures, frost may buildup at the evaporator during operation.
The unit will automatically start defrosting and the POWER indicator will flash.
The defrost control sequence is as follows:
A.When the unit operates in the cooling operation, drying operation, the ambient
temperature sensor senses that the evaporator coil temperature is below
-1°C(30°F). When the compressor stops operating for 10 minute s or the coil
temperature up to 7°C(45°F), the unit will restart to cool operating mode.
B.When the unit operates in the heating operation, drying operation, once the
coil temperature sensor senses the temperature of the evaporator is below 40°C
(104°F) and the differential temperature between coil temperature and room
temperature is below 19°C (66°F) after the compressor operation for 20
minutes, the unit start defrosting for 5 minutes and the power indicator blinking.
Press Up/Down repeatedly to
set the delay OFF time.
Press Up/Down repeatedly to
set the delay ON time.
19