Costway NP10883 Mode D'emploi page 7

This appliance shall be used only outdoors in a well-ventilated
space and shall not be used in buildings, garages, or any other
enclosed area.
The LP-gas supply cylinder must be disconnected when this
appliance is not in use.
Only cylinder marked propane shall be used.
Be sure to use only one 20lb( 9.1kg ) LP gas cylinder with a Type I
valve with this appliance as required by the American Nati
Standards Institute ( ANSI ) and the Canadian standards Steering
Committee
Never attempt to attach this appliance to the self-contained gas
system of a camper trailer, motorhome, or house.
Hand turn the manuals control valve. Never use tools. If the valve
will not tumble hand, do not try to repair it Call a Certified Gas
Technician. The use of force oneself attempted repair may result in
a fire or explosion.
WARNING: Improper installation, ad, alteration, service or
maintenance can cause injury or property damage. Refer to the
owner's information manual provided with this appliance. For
assistance or additional information consult customer service.
LP Hose and Regulator Assembly and Replacement
1. This appliance comes equipped with a standard P gas hose and
regulator including the appliance side connection for a CGA No791
Cylinder Connection Device. The P gas hose and regulator supplied
with this appliance must be used Only a hose and regulator
specified by the manufacturer can be used for replacement.
a) The CGA No79iconnectionincorporates an excess flow limiting
device that acts to limit the flow of gas if a leak is detected between
the regulator and the burner valve.
b ) If the burner valve is open prior to help gas cylinder service valve
being opened, the connection will interpret this free flow of Gas to
be a leak.
12
c ) The connection safety feature will reduce gas flow from the
regulator to the appliance to a minimal level.
d ) Be sure that the user control valve is closed prior to opening the
LP gas cylinder service valve to ensure that the connection flow
limiting device is not triggered mistakenly .
e) If the connection flow limiting device is triggered mistakenly, close
the gas cylinder service valve and the burner valve, wait for 10
seconds to allow the device to reset, open the cylinder service
valve, then open the burner valve and light the appliance as
perlighting instructions.
2. Be sure to protect the hose from any hot surfaces. Serious
danger may result if the hose contacts any hot surface.
3. Regular maintenance of the hose and regulator:
a) Inspect the hose before each use of the appliance. If the hose
shows signs of cracks, abrasions, cuts or damage of any kind, do
not operate the appliance. Fix or replace the hose as required
before using the appliance. For assistance with the repair o
replacement of the hose, call hero Manufacturing at
1-580-590-7341. Use only replacement parts from the manufacturer.
b) Inspect the seal inside the CGA No 791 service valve on the LP
gas cylinder when replacing the cylinder or at least once per year. If
there is any indication of damage, have the seal replaced by a
certified gas dealer before operating the appliance.
4. Do not use tools to tighten the CGA No 791 connection nut onto
the LP gas cylinder service valve. Hand tightens only.
5. Be careful to not cross the threads on the connection when
tightening the CGA No 791 connection onto the LP gas cylinder
service valve.
6. "Leak Test" should always be performed after attaching the
connection to the LP gas cylinder service valve.(See "Leak Test"
section of this manual)
7. For the connection of the hose and regulator to the LP tank, refer
to the "Connection" section of the LP gas cylinder section above.
13