Publicité
Les langues disponibles
Les langues disponibles
USING A LONG MATCH OR LIGHTER
1 Connect propane (LP)cylinder (see above pages).
2 Before lighting, move the lava rocks with a small shovel to allow
access to the burner.
WARNING: Lava rocks can become very hot. DO NOT touch unless
they are completely cooled.
3 Locate the burner control knob and make sure it isin the "OFF"
position.
4 Wearing heat resistant gloves, position a long-lit match or lit
long-neck lighter close to the burner ports. DO NOT lean over the
burner while lighting.
5 Push and turn burner control knob to the"LOW" position. The
burner shouldlitwithin5 seconds.
6 If ignition does occur within 5seconds, turn the burner control knob
to"OFF", wait 5 minutes for the gas to clear, and repeat the lighting
procedure. If the burner still will not light, refer to the troubleshooting
section.
7 Flame height can be changed by adjusting the burner control knob
between the "LOW" and "HIGH" positions.
8 Always check burner flames periodically to ensure proper
operation. Flames should be mostly yellow with some blue for best
performance.
26
TO EXTINGUISH
1. Push and turn the burner control
knob to the "OFF" position
2. Close the LP tank valve.
3. Disconnect the regulator from the
LP tank to close the gas supply
when not in use.
4. Make sure that the unit is
completely cooled before touching
any of the components or putting
on the cover.
ROUTINE CARE
● Keep your appliance free and clear from combustible materials.
● Visually inspect burner for obstructions, keep an enclosure free
and clear from debris.
● After the burner and lava rocks are completely cooled down, use a
soft brush to get rid of the mild stains of dirt and soil. Wipe with a
soft cloth.
STUBBORN STAINS
● Stubborn stains, discoloration, and possibly rust pitting can occur
from exposure to harsh outdoor conditions.
● Be careful not to let any powder or solvent come in contact with
painted or plastic components as damage may occur.
27
Publicité
