Hypertherm Powermax30 Mode D'emploi page 5

7. Thread the work lead through the plastic sleeve you removed in the previous step and then through the slots inside
the handle that act as a strain relief.
8. Line up the hole in the wire terminal with the hole in the handle of the ground clamp.
9. Insert the screw through the handle and the ring terminal on the end of the lead, and fasten it with the nut. Tighten the
screw to 34.6 kg-cm (30 inch-pounds).
10. Secure the work lead wire in the handle by folding one or both metal tabs over the wire, depending on the thickness
of the work lead.
For thinner work leads,
dress the wire to one side of the handle
and fold one metal tab over the wire.
11. Slide the plastic sleeve over the handle of the new ground clamp.
12. Reconnect the gas supply and power cord, and set the power switch to ON (I).
Powermax30/30 XP/30 Air/45/45 XP Field Service Bulletin 806530
All manuals and user guides at all-guides.com
Figure 2
Ground Clamp Replacement
For thicker work leads,
fold both metal tabs over the wire.
5