Hypertherm Powermax30 Mode D'emploi page 4

Ground Clamp Replacement
Replace the ground clamp
1. Set the power switch to OFF (O), disconnect the power cord from the power source, and disconnect the gas supply.
2. Slide down the black plastic sleeve on the handle of the clamp where the work lead is connected.
3. Straighten out the bent tab or tabs that hold the work lead in place. See Figure 1.
4. Loosen the screw that connects the work lead to the clamp.
5. Remove the work lead from the clamp, and discard the old clamp.
Screw through handle and work lead
1
Nut
2
6. On the replacement clamp, slide down the black plastic sleeve on the handle of the clamp where you want to
connect the work lead.

You can attach the work lead to either of the clamp's handles.
4
All manuals and user guides at all-guides.com
Figure 1
Powermax30/30 XP/30 Air/45/45 XP Field Service Bulletin 806530
1
2
Ring terminal
3
Strain relief tabs
4
3
4