Publicité
Les langues disponibles
Les langues disponibles
SM 1619X00347 11-04
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool speed can be
controlled from the minimum to the maximum
nameplate RPM by the pressure you apply to
the trigger. Apply more pressure to increase
the speed and release pressure to decrease
speed. This accurate speed control enables
you to drill without center punching. It also
permits you to use as a power screwdriver.
Bits are available for driving screws as well as
running bolts and nuts.
FORWARD/REVERSING LEVER &
TRIGGER LOCK
Your tool is equipped with a forward/
reversing lever and trigger lock located above
the trigger (Fig. 1). This lever was designed
for changing rotation of the chuck, and for
locking the trigger in an "OFF" position to help
prevent accidental starts and accidental
battery discharge.
* FORWARD/REVERSE INDICATOR LIGHTS
Your tool is equipped with lights which
indicates the rotation of the chuck.
For forward rotation, (with chuck pointed
away from you) move the lever to the far left
and the green indicator will light up.
For reverse rotation move the lever to the far
right and the red indicator light will light up .
To activate trigger lock move lever to the
center off position.
Do not change direction of
!
CAUTION
rotation until the tool
comes to a complete stop. Shifting during
rotation of the chuck can cause damage to
the tool.
ADJUSTABLE CLUTCH
Your tool features 26 clutch settings. Output
torque will increase as the clutch ring, is
rotated from 1 to 25. The drill "
position will lock up the clutch to permit
drilling and driving heavyduty work, and also
enables bits to be changed quickly and easily
in the keyless chuck.
11/9/04
10:43 AM
Page 8
All manuals and user guides at all-guides.com
Operating Instructions
* NOT AVAILABLE ON ALL MODELS
"
-8-
BRAKE
When the trigger switch is released it
activates the brake to stop the chuck quickly.
This is especially useful in the repetitive
driving and removal of screws.
GEAR SHIFTING
Your tool is equipped with two separate gear
ranges, low gear and high gear. Low gear
provides high-torque and slower drilling
speeds for heavy duty work or for driving
screws. High gear provides faster speeds for
drilling lighter work. To change speeds slide
switch, to the high or low position.
* AUXILIARY HANDLE
The auxiliary handle will provide additional
control, support and guidance for the tool. The
handle can be positioned on either side of the
tool. To mount, insert mounting bolt into
mounting hole, and simply thread handle onto
bolt until tight.
* SITE-LIGHT™
Your tool is also equipped with a light that
turns on automatically when the switch is
activated for better visibility during operation.
The Site-Light™ is maintenance free and was
designed to last the life of your tool.
* BATTERY CHARGED CONDITION
INDICATOR
The battery is equipped with a charged
condition indicator (Fig.1). The indicator
lights shows the charged condition of the
battery during the working process.
By pressing the button ON, the charged
condition can also be checked when the
battery is removed or when the machine is
not in use.
• • • When all three lights are illuminated,
this indicates the batter pack is fully
Charged.
• •
When only two lights illuminate, this
indicates the batter pack is partially charged.
•
When only one light illuminates, this
indicates the battery pack is slightly charged.
When no lights illuminate, this indicates the
battery pack is completely discharged.
Publicité
