Transport, Packaging And Storage; Commissioning, Operation; Mechanical Mounting - WIKA FSD-4 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. Transport, packaging and storage / 5. Commissioning, operation

4. Transport, packaging and storage

4.1 Transport
Check the flow switch for any damage that may have been caused by transport.
EN
Obvious damage must be reported immediately.
4.2 Packaging and storage
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change in installation site, sending for repair).
Permissible conditions at the place of storage:
Storage temperature: -20 ... +80 °C [-4 ... +176 °F]
Avoid exposure to the following factors:
Direct sunlight or proximity to hot objects
Mechanical vibration, mechanical shock (putting it down hard)
Soot, vapour, dust and corrosive gases
Humid or wet environment
Hazardous environments, flammable atmospheres

5. Commissioning, operation

5.1 Mechanical mounting

Only use the flow switch if is in perfect condition with respect to safety. Prior to commissioning, the flow switch must be
subjected to a visual inspection.
Commissioning and operation of the instrument may only be carried out by skilled personnel, see chapter 3.3 "Person-
nel qualification".
10
WIKA operating instructions flow switch, model FSD-4

Publicité

Table des Matières
loading

Table des Matières