Publicité
Les langues disponibles
Les langues disponibles
EN
When the Disinfection cycle has finished, the system
shuts off and the display reverts to STANDBY. Turn
the handle of the pop-up waste to empty the tub.
DISINFECTION DOES NOT START!!!
If the message "ADD WATER" is displayed, fill the
tub to the level at which the Disinfection cycle is
able to start.
DISINFECTION DOES NOT START!!!
If the message "ADD DISINFECTANT" is displayed,
replenish the dispenser with liquid so that the
Disinfection cycle is able to start. Remove the
Disinfectant dispenser cap, turning anticlockwise.
Fill the container with Disinfectant so that the
function can start. Replace and secure the
dispenser cap.
Use only disinfectant solution supplied by Teuco.
POSTPONING THE DISINFECTION CYCLE
To postpone the disinfection cycle, press the "O/I"
button; the system shuts off and the display reverts
to STAND-BY.
Turn the handle of the pop-up waste to empty the
tub.
AUTOMATIC SHUTOFF: If there is no response within 5 seconds when the display prompts START
DISINFECTION?, the system shuts off and the display reverts to STAND-BY. DISINFECTION of the
system is not carried out.
18
START
DISINFECTIoN?
Display showing
Disinfection prompt
20:30
Display in STAND-BY mode
ADD
WATER
Display in DIAGNOSTICS mode
ADD
SANITIZER
Display in DIAGNOSTICS mode
20:30
Display in STAND-BY mode
HYDROTOP - Hydrosilence
Publicité
