DeWalt XR DCN693 Traduction De La Notice D'instructions Originale page 62

english
SYMPTOM CAUSE
Tool operates but does Depth adjust set too shallow
not drive fasteners fully
Tool not firmly applied to workpiece
Material and fastener length
Damaged or worn driver blade tip
Damaged actuation mechanism
Tool is not yet run-in
Use of incorrect speed (DCN693 only)
Tool operates, but no No nails in magazine
fastener is driven
Wrong size or angle nails
Debris in nosepiece
Debris in magazine
Worn magazine
Damaged or worn driver blade
Damaged pusher spring
Jammed nail Wrong size or angle nails
Magazine screws not secured after
previous jam clear/inspection
Damaged or worn driver blade
Material and fastener length
Debris in nosepiece
Worn magazine
Dry drive lock out is engaged with only
7-9 nails remaining in magazine and
the user is applying excessive force to
contact trip, overriding the lockout
Tool is not yet run-in
Use of incorrect speed (DCN693 only)
Poor driving hole Damaged or worn hole locating tip
performance
60
All manuals and user guides at all-guides.com
FIX
Rotate depth adjust to a deeper setting.
Apply adequate force to tool securing it tightly to
workpiece. Refer to instruction manual.
If the unit continues to stall (forcing the need
to rotate the Stall release lever) choose the
appropriate material and fastener length that is not
too rigorous of an application.
Replace driver/return assembly. See authorised
D WALT repair agent.
e
See authorised D WALT repair agent.
e
New tools can take 500–1000 nails for parts to
mesh and wear in together. Drive shorter nails
during this period if experiencing difficulty driving
nails flush.
If trying to drive longer ring shank nails in soft
woods, or driving ring shank nails into harder
materials in speed 1 - adjust speed setting to
position 2.
Load nails in magazine.
Use only the recommended nails. Refer to
Technical Data.
Clean nose area and watch closely for small pieces
of broken nails stuck in the track.
Clean magazine.
Replace magazine. See authorised D
agent.
See authorised D WALT repair agent.
e
Replace spring; see authorised D
agent.
Use only the recommended nails. Refer to
Technical Data.
Make sure to tighten magazine hex bolts with
wrench provided.
Replace driver blade. See authorised D
repair agent.
If the unit continues to stall (forcing the need
to rotate the Stall release lever) choose the
appropriate material and fastener length that is not
too rigorous an application.
Clean nose area and watch closely for small pieces
of broken nails stuck in the track.
Replace magazine. See authorised D
agent.
Load more nails in magazine to disengage dry drive
lockout.
New tools can take 500–1000 nails for parts to
mesh and wear in together. Drive shorter nails
during this period if experiencing difficulty driving
nails flush.
If trying to drive longer ring shank nails in soft
woods, or driving ring shank nails into harder
materials in speed 1 - adjust speed setting to
position 2.
Replace tip with kit. If poor performace remains
take tool to an authorised D WALT repair agent.
e
WALT repair
e
WALT repair
e
WALT
e
WALT repair
e