Télécharger Imprimer la page

Makita UC100D Manuel D'instruction page 9

Masquer les pouces Voir aussi pour UC100D:

Publicité

Les langues disponibles

Les langues disponibles

Switch action
WARNING:
For your safety, this tool is
equipped with lock-off lever which prevents the
tool from unintended starting. NEVER use the tool
if it runs when you simply pull the switch trigger
without pressing the lock-off lever. Return the
tool to our authorized service center for proper
repairs BEFORE further usage.
WARNING:
NEVER tape down or defeat pur-
pose and function of lock-off lever.
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
NOTICE:
Do not pull the switch trigger hard with-
out pressing the lock-off lever. This can cause
switch breakage.
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided. To start the tool,
depress the lock-off lever and pull the switch trigger.
Release the switch trigger to stop.
1
Fig.5
► 1. Switch trigger 2. Lock-off lever
Checking the run-down brake
CAUTION:
If the saw chain does not stop
within a few seconds in this test, stop using the
tool and consult our authorized service center.
Run the tool, and then release the switch trigger com-
pletely. The saw chain must come to a standstill within
a few seconds.
ASSEMBLY
CAUTION:
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
hands. Always wear gloves when handling the saw chain.
Removing or installing saw chain
CAUTION:
still hot just after the operation. Let them cool down
enough before carrying out any work on the tool.
CAUTION:
ing or removing saw chain in a clean place free
from sawdust and the like.
Removing the saw chain
To remove the saw chain, perform the following steps:
1.
Pull the lever up.
2
Fig.6
► 1. Lever
2.
Turn the lever counterclockwise until the sprocket
cover comes off.
Fig.7
► 1. Sprocket cover 2. Lever
9 ENGLISH
Always be sure that the tool is
Do not touch the saw chain with bare
The saw chain and the guide bar are
Carry out the procedure of install-
1
2
1

Publicité

loading