Publicité
Les langues disponibles
Les langues disponibles
8.
Fit one end of the saw chain on the top of the
guide bar.
9.
Fit the other end of the saw chain around the
sprocket, then attach the guide bar to the tool body so
that the hole on the guide bar is aligned with the pin on
the body.
Fig.13
► 1. Sprocket
Press the guide bar against the tool body to release the
pin. The saw chain tension is automatically adjusted.
3
1
Fig.14
► 1. Saw chain 2. Pin 3. Sprocket
10. Place the sprocket cover so that the bolt and pin
on the tool body meet their counterparts on the sprocket
cover.
Fig.15
► 1. Sprocket cover 2. Bolt 3. Pin
11.
secured then return it to the original position.
Fig.16
► 1. Lever 2. Sprocket cover
1
Make sure that the saw chain does not loose and the
saw chain can be moved smoothly back and forth. If
necessary, adjust the tension of the saw chain by refer-
ring to the section for adjusting saw chain tension.
Adjusting saw chain tension
jump off the bar and it may cause an injury or
accident.
The saw chain may become loose after many hours
of use. From time to time check the saw chain tension
before use.
If the saw chain is loose, adjust the saw chain tension.
1.
2
1
2
Fig.17
3
► 1. Lever
11 ENGLISH
Turn the lever clockwise until the sprocket cover is
CAUTION:
A chain which is too loose can
Pull the lever up.
1
2
1
Publicité
