Hypertherm Powermax65/85 Mode D'emploi page 8

Power Cord and Strain Relief Replacement
Loosen the rear panel of the plasma power supply
1. Remove the end panel bracket
that you must first remove.
2. Put the fan side of the plasma power supply on a clean, dry, and flat surface.
3. Remove the screws
Some models have 2 screws on the bottom of the plasma power supply, and other models have
3 screws on the rear panel instead.
8
. Some models have 2 screws
1
2
that attach the rear panel to the bottom of the plasma power supply.
3
807020 Field Service Bulletin
on the end panel bracket
2
2
1
Powermax65/85, Powermax65/85 SYNC