Hypertherm Powermax65/85 Mode D'emploi page 17

3. Fold the top of the component barrier
the top edge of the power PCB, inside the
plasma power supply frame and under the
end panel bracket.
4. Make sure that all of the wires that are
connected to the power PCB are behind the
component barrier.
5. Put the cover
Do not pinch any wires.
6. Install the 16 screws
supply cover. Tighten the screws to 1.7 N·m
(15 lbf·in).
Powermax65/85, Powermax65/85 SYNC
on the plasma power supply.
4
on the plasma power
5
Field Service Bulletin
onto
3
3
807020
Power Cord and Strain Relief Replacement
4
5
17