Publicité
Les langues disponibles
Les langues disponibles
Power Cord and Strain Relief Replacement
Attach the strain relief
1. If the retaining nut
2. On the outside of the plasma power supply, put the strain relief
the plasma power supply. If your model has a strain relief adapter
the adapter.
3. On the inside of the plasma power supply, install the hex nut
has a washer
12
4
is on the strain relief
1
, first put the washer on the strain relief. Tighten the hex nut with your hand.
5
807020
2
4
5
3
, remove the retaining nut.
2
4
Field Service Bulletin
2
1
in the hole in the rear panel of
2
, first put the strain relief in
3
on the strain relief. If your model
Powermax65/85, Powermax65/85 SYNC
Publicité
