Publicité
Les langues disponibles
Les langues disponibles
MA INTENA NCE
AUGER
CONTROL
CABLE
ADJUSTMENT
,_
WARNING:
Do not over-tighten,
as this may lift the
lever and cause
the auger
drive
to be engaged
without
depressing
the auger
drive
control,
1. With the auger control lever released, the hook (A, Figure 17)
should barely touch the lever (B) without raising it. There can
be a maximum of 1/32 in. (0.8 mm) clearance.
2. To adjust, loosen the nut (C) by holding the adjusting flats (D)
and turning the nut. Then, turn the adjusting flats and hold the
adjustment screw (E). The adjustment screw is a phillips screw
and the head can be held or turned by inserting a screwdriver
through the spring (F).
3. Hold the adjusting flats and tighten the nut.
4. Start the engine and check the auger. The auger must not be
engaged unless the auger control lever is depressed.
5. With the engine running, fully depress the auger drive control
lever. The auger should engage and run normally.
I
WARMNG: The auger must stop within 5 seconds. If it I
does not, see an authorized
dealer.
I
6. Release the auger control lever.
7. If the auger does not operate properly, stop the engine and
recheck the auger control cable adjustment.
8. If the drive linkage is properly adjusted, the tension of the
auger drive belt may require an adjustment. See an authorized
dealer.
CHECK
THE TIRES
Check tires for damage. Check the air pressure in the tires with an
accurate gauge (see Figure 18).
,_
CAUTION: Avoid injury! Explosive separation of tire and
rim parts is possible when they are serviced incorrectly.
, Do not attempt to mount a tire without the proper equipment
and experience to perform the job.
, Do not inflate the tires above the recommended pressure.
, Do not weld or heat a wheel and tire assembly. Heat can
cause an increase in air pressure resulting in an explosion.
Welding can structurally weaken or deform the wheel.
, Do not stand in front or over the tire assembly when
inflating. Use appropriate
tool that allows you to stand to
one side.
NOTICE:
Check
side of tire for maximum
tire pressure.
DO NOT
exceed
maximum.
\
Adjusting Auger Control Cable
Figure 17
Checking Tire Air Pressure
Figure 18
21
Publicité
