Rupes HLR75 Traduction Des Instructions Originales page 9

WARNING: If a case of unusual vibration is present after a start of the tool, switch-off the tool immediately and
eliminate the fault.
WARNING: To reduce the risk of injury, turn the knob until OFF position (position 0) after any use.
ELECTRONIC CONTROLLER
Soft start
The soft start is electronically controlled. The soft start guarantees the motor and battery protection and reduces the risk of injury
for the operator.
Speed control
The speed of the tool can be changed by rotating the speed regulation knob (2) to the desired setting.
The speed regulation knob can be set speed for any speed between 3000 and 5500 RPM.
Tool Protections
The electronic protection protects the tool from different events that can damage the tool and create a risk of injury for the
operator. It also guarantees a longer life.
NOTICE: in a case of overcurrent or overheating caused by repeated starts or excessive overloads, the protection limits the
tool power consumption and reduce RPM. If the condition continues, the electronic protection turns off the tool.
ACCESSORIES ASSEMBLY AND DISASSEMBLY
WARNING: Before (dis)assembling the tool assure that the speed regulation knob (2) is in OFF position (0
position).
NOTICE: For have the optimal tool performance use only original accessories and consumables.
Backing Pad
- Place the backing pad (4) in the center; slightly turn the backing pad until it is in the correct position on the spindle. (Fig. 1)
- Tighten the backing pad fixing screw (7) using the Allen wrench (8). (Fig. 2)
- For disassembly: Unscrew pad's mounting screw (7) using the wrench (8). (Fig. 3)
NOTICE: Fitting non-original or incorrect sized backing pads may cause excessive vibration of the tool.
Polishing Foam
- Used polishing pad can be removed by simply tearing them off;
- Apply the new polishing pad by pressing the same on the backing pad;
NOTICE: Only Ø 80-100 mm polishing foam for backing pad Ø75 mm are allowed.
NOISE EMISSION VALUES
Noise emission values determined according to EN 62841-1:
SOUND PRESSURE LEVEL
SOUND POWER LEVEL
UNCERTAINTY (K)
Use ear protection!
VIBRATION EMISSION VALUES
Vibration total values a h (triax vector sum) and uncertainty K determined according to EN 62841-1:
3 AXIS VIBRATION LEVEL (a h )
UNCERTAINTY (K)
Displayed emission values are comparative and are to be employed for a provisional assessment of the operator's risk exposure
during the work period. Appropriate evaluation of work period must also include tool's idle and stop periods. These emission
values represent the tool's main applications. If the tool is used for other applications, with other accessories, or if it does not
undergo regular maintenance, emission values can significantly increase during operations.
CAUTION: The indicated measurements refer to new power tools. Daily usage causes the noise and vibration values to change.
MAINTENANCE AND SERVICING
WARNING: All maintenance operation must be performed with the power disconnected.
Make sure to remove the power supply 9HP180LT or battery pack 9HB180LT from the tool and that the knob is in the OFF
position.
dB(A)
dB(A)
dB
m/s
2
m/s
2
HLR75
77.5
88.0
3.0
HLR75
3.98
0.44
9