Rupes HLR75 Traduction Des Instructions Originales page 7

WARNING: To reduce the risk of injury, user must read instruction manual
CE mark for EU market
Wear ear protection
Wear gloves
Disposal of decommissioned (WEEE Directive)
Eurasian conformity mark
n0 No-load speed
TYPE
Voltage D.C. [V]
R.P.M.
Electronic speed control
Battery life [min]
Ø Orbit [mm]
Ø Backing Pad [mm]
Ø Backing Foam [mm]
Backing Pad Thread
Weight [Kg]
* The value is referred to a use of the battery pack 9HB180LT, fully charged with the charger 9HC180LT.
** measured without the functional units: battery pack or power supply.
WARNING! Read all safety warnings, instructions, illustrations and specifications provided with this power
tool. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. Save all warnings and
instructions for future reference. The safety and accident prevention instructions are reported in the "SAFETY INSTRUCTION"
booklet which is an integral part of these documents. This operating instructions manual indicates the additional information
required for the specific use of the tool.
CORRECT USAGE
• This tool is designed to be used as a polisher. Read all safety warnings, instructions, indications provided on drawings
and specifications provided with this tool. Failure to comply with all instructions provided below may cause electrical shocks,
fire and/or serious injuries.
• This tool is not intended to be used for smoothing, metal brushing and cutting operations. The use of this tool for unintended
applications may cause hazards and injuries to people.
• The tool must be used with accessories that have been specifically designed or recommended by the manufacturer. The
fixing of the accessory to the tool does not guarantee a safe operation.
• The rated speed of the accessories must be at least equivalent to the maximum speed specified on the tool. Using the
accessories at speeds above the rated one, may cause them to break or be thrown into the air.
• The external diameter and thickness of the accessories must match the specifications of the tool. Accessories with incorrect
dimensions cannot be adequately protected or controlled.
• The configuration of accessories must match the tool. The use of accessories that cannot be perfectly fitted on the tool may
result in imbalance, excessive vibrations and in the impossibility of controlling the tool.
• Do not use damaged accessories. Before use, inspect all the accessories. Inspect the supporting pads and verify there
are no cracks, tears or excessive wear. If the tool or accessory has fallen, verify that it is not damaged or install a new
accessory. After inspecting or installing an accessory, test the operation of the tool at maximum speed and without load
for one minute, keeping at a safety distance. If the accessories are damaged, they will break during this test.
Summary of device labels containing safety information
TECHNICAL SPECIFICATIONS
Wear eye protection
Wear a mask
Product contains lithium-ion battery
Li-Ion
Direct Current
/min Per minute
HLR75
18
3000÷5500
•
~45*
12
75
80-100
M6
1,1**
ENGLISH
7