Publicité
Les langues disponibles
Les langues disponibles
The main consideration when installing any refrigeration unit into a custom kitchen
is ventilation. The heat removed from the cooling and/or freezing compartments needs to be
dissipated into the atmosphere. Incorrect ventilation can lead to premature
compressor failure, excessive power consumption, moisture buildup and mould, total system failure and will likely
invalidate the warranty provided with the appliance.
For products intended to be installed into a cabinet, the following
requirements need to be met:
INSTALLATION INSTRUCTION
An air passageway should be
provided in the top of the
cabinet run to allow free air in
and out.
There should be space at the rear of
the cabinet to allow cool air to be
drawn over the condenser.
A cutout should be made in the plinth
below the fridge/- freezer and this
finished neatly using the air vent grille.
Alternatively, a thin section of the plinth
can be removed to allow air into the unit
(recommended 50cm x 4cm)
8
Publicité
