Napoleon GL22N Instructions D'installation Et D'utilisation page 18

18
10.0 TROUBLESHOOTING
TURN OFF THE GAS AND ELECTRICAL POWER BEFORE SERVICING THE APPLIANCE.
APPLIANCE MAY BE HOT, DO NOT SERVICE UNTIL APPLIANCE HAS COOLED.
SYMPTOM
Pilot will not light.
Makes noise with
no spark at pilot
burner.
IGNITOR
(SPARK)
SENSOR
PILOT TUBE
Pilot sparks but
will not light.
W415-1101 / A / 07.24.12
All manuals and user guides at all-guides.com
MAINTENANCE
MAINTENANCE
MAINTENANCE
!
DO NOT USE ABRASIVE CLEANERS.
PROBLEM
Battery.
Wiring.
Loose connection.
Module.
Electrode.
Igniter Spark gap is
incorrect.
A shorted or loose
Connection.
Improper switch wiring.
Module is not grounded.
Gas supply.
Out of propane gas.
WARNING
TEST SOLUTION
- Check batteries.
- Verify the wire for the sensor and the wire for the
ignitor are connected to the correct terminals (not
reversed) on the module. NOTE: Sensor has 3/16"
connection and ignitor has 1/8" connection.
- Verify no loose connections, electrical shorts in the
wiring or ground out to any metal object.
- Turn the ON/OFF switch to the "OFF" position.
Remove the igniter wire from the module. Place
the ON/OFF switch to the "ON" position. Hold a
grounded wire about 3/16" away from the ignitor
(spark) terminal on the module. If no spark the
ignitor terminal module must be replaced. If there is
a spark the ignitor terminal is fi ne.
- Inspect pilot assembly for a shorted wire or cracked
insulator around the electrode.
- Spark gap of the ignitor to the pilot should be 1/8".
- Remove and reinstall the wiring harness that plugs
into the module. Remove and verify continuity of
each wire in wiring harness.
- Troubleshoot the system with the simplest ON/OFF
switch.
- Verify the valve and pilot assemblies are properly
grounded to the metal chassis of the appliance or log set.
- Verify that the incoming gas line ball valve is
"Open". Verify that the inlet pressure reading is
within acceptable limits, inlet pressures must not
exceed 14" W.C.
- Fill the tank.
42.25