WIKA GDT-20 Mode D'emploi page 37

5. Commissioning, operation
System requirements
At least Microsoft Windows
®
Windows is a registered trademark of Microsoft Corporation in the United States and other countries.
5.4.2.1 Factory setting
The COM port allocated at the PC has to be set for the access to the transmitter. Upon
delivery, the address is set to 247 and the baud rate is configured with 19,200.
With these settings, the transmitters can be read via the button
Configuration
TAG number: WIKA
■
Address: 247
■
Baud rate: 19,200
■
Parity: none
■
Scheduling: Off
■
Gas mixture SF [%]: 100 %
■
6
Gas mixture partner: N
■
5.4.2.2 Writing new parameters
Take note of the new communication parameters before writing them, as the parameters will
be required again for any new access to the transmitter.
Write the new values in the right fields (below the button "Write on instrument").
WIKA operating instructions transmitter, models GDT-20 and GDHT-20
7 (32-bit)
®
2
"Load instrument data".
EN
37