Publicité
Les langues disponibles
Les langues disponibles
•
Dual suction fittings shall be placed in such locations and distances to avoid "dual
blockage" by a user.
•
Dual suction fittings shall not be located on seating areas or on the backrest for such
seating areas.
•
The maximum system flow rate shall not exceed the values shown in the "Pipe Sizing
Chart" found below.
•
Never use pool or spa if any suction outlet component is damaged, broken, cracked,
missing, or not securely attached.
•
Replace damaged, broken, cracked, missing, or not securely attached suction outlet
components immediately.
•
In addition to two or more suction outlets per drive installed in accordance with latest
IAF (formerly NSPI) standards and CPSC guidelines, follow all applicable national,
state, and local codes.
•
Installation of a vacuum release or vent system, which relieves entrapping suction, is
recommended.
!
WARNING – Hazardous Pressure. Pool and spa water circulation systems operate
under hazardous pressure during start-up, normal operation, and after drive shut-off.
Stand clear of circulation system equipment during drive start-up. Failure to follow safety
and operation instructions could result in violent separation of the drive housing and cover
due to pressure in the system, which could cause property damage, severe personal in-
jury, or death. Before servicing pool and spa water circulation system, all system and drive
controls must be in off position and filter manual air relief valve must be in open position.
Before starting system drive, all system valves must be set in a position to allow system
water to return back to the pool. Do not change filter control valve position while system
drive is running. Before starting system drive, fully open filter manual air relief valve. Do
not close filter manual air relief valve until a steady stream of water (not air or air and
water mix) is discharged from the valve. All suction and discharge valves MUST be OPEN
when starting the circulation system. Failure to do so could result in severe personal injury
and/or property damage.
!
WARNING – Separation Hazard. Failure to follow safety and operation instructions
could result in violent separation of drive components. Strainer cover must be properly
secured to drive housing with strainer cover lock ring. Before servicing pool and spa cir-
culation system, all system and drive controls must be in off position and filter manual air
relief valve must be in open position. Do not operate pool and spa circulation system if a
system component is not assembled properly, damaged, or missing. Do not operate pool
and spa circulation system unless filter manual air relief valve body is in locked position
in filter upper body. All suction and discharge valves MUST be OPEN when starting the
circulation system. Failure to do so could result in severe personal injury and/or property
damage.
!
WARNING – Never operate or test the circulation system at more than 50 PSI max.
SAVE THESE INSTRUCTIONS
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
2
2
Publicité
