Publicité
Les langues disponibles
Les langues disponibles
Valve Internals Assembly Kit Replacement Instructions
1.
Turn pump OFF. Close all valves; pump to valve (or pool to pump), filter to pool.
2.
Open Air Relief valve, located on top of filter.
3.
Turn multi-port valve to "WASTE" position. Allow 3-5 minutes for water to drain from the filter
tank.
4.
From present (old) multi-port valve assembly, remove all the bolts and nuts on top of the valve.
5.
Remove the valve cover and internals assembly by the handle, out of the valve body. Clean any
debris left inside the valve flat sealing surfaces.
6.
Replace valve cover and internals assembly with new kit. Make sure all the parts are clean.
IMPORTANT - Make sure that the "FILTER" position of the cover label is toward the filter ports.
7.
8.
Replace all the bolts and nuts and tighten in a crisscross pattern.
9.
Turn the valve handle to "FILTER" position.
10. Open all valves (from pump to valve and filter to pool).
11. Turn pump "ON".
12. Close Air Relief valve on top of filter, when a steady stream of water is being discharged.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
10
Publicité
