Publicité
Les langues disponibles
Les langues disponibles
en-us Installation procedure
2.
CAUTION Do not let the cooktop drop into place.
Make sure that the cooktop is supported along the
▶
edges when carefully placing it into the cutout.
Turn the cooktop over carefully making sure not to dam-
age the pressure regulator and gas line. Place the cook-
top carefully into the countertop cutout, pushing it to-
wards the front of the cutout. Make sure the cooktop is
centered between the left and right edges of the cutout.
Insert the 2½" clamping screws into the hold-down
3.
bracket and secure the cooktop to the countertop
Protect delicate countertops by placing a wooden disk
underneath. Tighten the screws to the cooktop
Note: Do not use silicone to glue the cooktop to the
countertop surface.
10
4.4 Connection overview
Refer to this illustration for the location of the gas and
electric connection of the appliance.
a Cooktop rough-in box
b Arrow on pressure regulator, shows the direction of
gas flow
c Pressure regulator
.
d ½" female pipe threads
e Metal flex gas line
.
f Power cord (40"/1 m)
g 120 V receptacle
h Gas cut-off valve
i
Gas supply line connection fitting
j
Floor
4.5 Connecting the gas supply line
Note
Ensure the following requirements are met before you try
to connect the appliance to the gas supply:
The appliance is shipped from the factory for use with
¡
natural gas. If you want to use propane gas it must be
converted. A qualified technician or installer must do the
conversion.
Before connecting the appliance, please check whether
¡
the local connection conditions such as gas type and
gas pressure match the appliance settings.
Make sure the gas supply is turned off at the manual
¡
shutoff valve before connecting the appliance.
The gas connection must be in a location that permits
¡
access to the manual shut-off valve and which, if appli-
cable, is visible after opening the door of the cabinet.
The metal flex gas line must not come into contact with
¡
moving parts of the fitted unit (e.g. drawers) or be laid in
areas where it could become trapped or damaged.
The metal flex gas line must not come into contact with
¡
a cooktop, oven, dishwasher, refrigerator, washing ma-
chine, hot water pipe, radiator or any other appliance in-
stalled in the vicinity of the gas cooktop.
The metal flex gas line must not be subject to rubbing,
¡
vibrations, kinking or any other kind of deformation. It
should be checked along its entire length with the cook-
top in the installation position.
Publicité
