Publicité
Les langues disponibles
Les langues disponibles
8- Care and cleaning
8-5.1
Note: Hygiene
After long periods of disuse we recommended to run programme HYGIENIC with no
load and small amount of detergent in washing agent compartment (2) or special ma-
chine cleaner to remove possibly corruptive residues.
8-6.1
8-6.3
8-6.5
22
8-5.2
8.5 Long periods of disuse
If the appliance is left idle for a longer period:
1. Pull out the electrical plug (Fig. 8-5.1).
2. Turn off water supply (Fig. 8-5.2).
3. Open the door to prevent formation of moisture
Before next usage check carefully power cord, water
inlet and drain hose. Make sure everything is properly
installed and without leackage.
8.6 Pump filter
8-6.2
Clean the filter once a month and check the pump filter
for instance if the appliance:
▶
▶
▶
Scalding Risk! Water in the pump filter can be very
hot! Before any action please ensure water has
cooled down.
8-6.4
1. Turn off and unplug the machine (Fig. 8-6.1).
2. Open service flap. You can either use a coin or a
3. Provide a flat container to catch leach water
4. Pull the drainhose out and hold its end above the
5. Take the sealing plug out of the drainhose (Fig.
8-6.6
6. After complete drainage close drainhose (Fig.
7. Unscrew and remove counter clockwise the pump
8. Remove contaminants and dirt (Fig. 8-6.6).
and odours. Let door open while not used.
doesn´t drain the water.
doesn´t spin.
cause unusual noise while running.
WARNING!
screwdriver (Fig. 8-6.2).
(Fig. 8-6.3). There could be bigger amounts!
container (Fig. 8-6.3).
8-6.3).
8-6.4). and push it back into the machine.
filter (Fig. 8-6.5).
EN
Publicité
