Starting - Toyota R01 Manuel Du Propriétaire

3. Slide the card outwards to detach it from the holder.
1
NOTE
• Never eject the microSD card while the Dashcam is accessing
the card (LED is on or blinking). Doing so may corrupt the
currently recording file, or damage not only the microSD card
but also the Dashcam itself.
• Before ejecting the microSD card, confirm that the Dashcam
power is off (All LEDs are off).
• The Dashcam does not work without insertion of a microSD
card. Be careful not to forget to insert a microSD card when
done. When the card slot is empty, you will hear continuous
high-tone beeps.

3. Starting

The Dashcam will automatically power on and start loop recording
(2-minute video files) when the vehicle ignition key is turned on
or for vehicles equipped with push button start, when the ignition
button is pressed.
When the Dashcam is on and recording, the green LED from the
power button will illuminate continuously, accompanied by a short
high tone beep at start up.
NOTE
• Just after formatting the microSD card, the Dashcam creates
files that are necessary for recording the videos. Therefore,
the time until completion of the startup becomes longer.
• Recording a video is not ready until startup is done. The
Dashcam starts recording just after startup is finished.
• When an abnormal vibration and/or a shock is detected while
the vehicle is parked, the Dashcam powers on automatically
and records the video of the surrounding area in its field of
view for approximately 60 seconds (Parking Mode).
2 3
21