Bosch VMD01-M50 PAL Manuel D'utilisation page 13

All manuals and user guides at all-guides.com
5.2.2 Sensor parameter set 1 or 2
See chapter 3.1 (overlaid lines)
Area of sensitivity set 1 or 2
The live image is shown with the sensitive, undarkened area. With the
right mouse button pressed, square non-sensitive areas can be pulled up.
After releasing the mouse button these are darkened and shown. Multiple
non-sensitive areas of different sizes can be distributed on the image. With the
left mouse button, non-sensitive areas can be deleted or modified by drawing
over them; sensitive areas can be added with the right mouse button.
Drawing in object size/perspective set 1 or 2
The live image is shown with a small rectangle. Its size is the factory-set
default, not the minimum size. No perspective is set. Everything larger than
the plotted rectangle is detected. The frame can be changed in size, moved
about on the image, or another frame pulled up using the left mouse button. The
larger frames show the minimum object size to be detected in the foreground.
The smaller frames show the minimum object size in the background. The
position of the frames relative to each other shows the perspective set. Note
that the position of the perspective always only runs horizontally or vertically,
even when the rectangles on the image are arranged diagonally. If one thinks of
both rectangles as the endpoint of an "L" lying parallel to the image edges, the
longer side indicates the position. If the relative sizes of the frames are
changed, the colors or types of lines also change. The rectangles can be
deleted by dragging a frame with the right mouse button. If both rectangles are
deleted, the small rectangle reappears.
Programming, continued
– 13 –
English
A1 February 03/Trb