Costway TQ10105 Manuel De L'utilisateur page 6

Attach the Steering Wheel
HINT: Batteries Not Included
1. With a screwdriver
loosen the screw on the
battery cover located in
the center of the steering
wheel.
2. Remove the battery
cover from the top of the
battery compartment.
3. Insert 2x1.5 AA batteries in their correct polarities.
4. Place the battery cover over the battery compartment and fasten
with the screw you removed in step one.
Remove the M5x30 machine screw and Ø5 nut from the steering wheel.
Turn the vehicle body upright.
5. Place the steering wheel over the the steering column, protruding
from the middle of the steering wheel base.
6. Align the holes on each side of steering wheel with the holes at the
end of the steering column. Reinsert the M5x35 machine screw.
7. Fasten a nut on the opposite end of the screw to secure the steering
wheel to the steering column.
6
10
3
4 2
1
7
5
Attach the Protection Cover
1
1. Plug the connector on the battery to the connector on the body.
Remove the screws on the front protection cover with a screwdriver.
2. Fit the protection cover to the body.
3. Insert and tighten the M5X12 machine screw.
4. Fit the rear spoiler to the rear side of the vehicle body. Press down
firmly until it clicks into place.
4
EN
3
2
11