Publicité
Les langues disponibles
Les langues disponibles
Attach the Right Driving Wheel
1
1
3
5
6
7
Use scissors to cut the cable tie on the gear box.
1. Insert the longer end of the rear axle into the hole on the rear
side of the vehicle body.
2. Lift the gear box up until the rear axle can pass through the hole
on the gear box.
3. Adjust the rear axle and make sure that the square on the rear
axle fits into the body.
4. Slide a driving wheel from the end of the rear axle with the gear
box.
5. Slide a Ø10 washer to rear axle.
6. Insert a split pin into the hole at the end of the rear axle. Bend
the ends of split pins back using a long nose pliers (not included).
7. "Snap" a wheel cover to the driving wheel.
08
Gear box
2
2
Rear
Bottom
View
4
Attach the Left Rear Wheel & Front Wheels
Rear Bottom View
1 1
1. Slide a Ø10 washer to the other end of the rear axle.
2. Slide a driving wheel to the rear axle.
3. Slide a Ø10 washer to the rear axle.
4. Insert a split pin into the hole at the end of the rear axle. Bend the
ends of split pins
back using a long nose pliers (not included).
5. "Snap" a wheel cover to the driving wheel.
7
9
9
8
8
1 1 0
10
6. Slide a Ø10 washer to one end of the front axle.
7. Slide a front wheel to the front axle.
8. Slide a Ø10 washer to the front axle.
9. Insert a split pin into the hole at the end of the front axle. Bend
the ends of split pins back using a long nose pliers (not included).
10. "Snap" a wheel cover to the wheel.
Repeat steps 6-10 to assemble the other side of the front wheel.
EN
2
3
4
5
Rear Bottom View
6
09
Publicité
