VALBERG WF 914 A W180C Consignes D'utilisation page 31

C
Cleaning and maintenance
Problem
The machine vibrates during
the spin cycle.
The final spin is not
producing satisfactory
results.
If the washing machine has
a time display: the duration
of the program initially
displayed is increased/
decreased by time intervals:
Enter the after-sales query mode
1. In the OFF mode. press the « » + « Options » + «
2. It displays the number of operation cycles.
3. Press « Options » to switch cycles or fault codes.
4. When querying fault codes, press the «
Check that
• The washing machine is correctly levelled and is
resting correctly on its four feet;
• The transit bolts have been removed. Before using
the machine, the transit bolts must be removed.
• The washing machine is fitted with a system for
detecting and adjusting unbalances. If heavy clothing
(e.g. : bathrobes) is placed in the washing machine,
the system is able to automatically adjust the spin
speed or even stop a spin cycle, that has begun, if
it detects an unbalance that is too high. This is to
protect the appliance.
• If the laundry is still too wet at the end of the cycle,
remove some items and restart the spin cycle.
• Excessive foam can prevent the spin cycle. Use a
suitable amount of detergent.
• Check that the Spin mode speed selector has not
been set to "0".
This is normal and allows the machine to automatically
adjust the duration of the program depending on
various factors e.g. :
• Excessive foam;
• Load unbalances due to the presence of heavy items;
• Longer heating times due to the low temperature of
the inlet water.
In view of these factors, the remaining duration of the
program is recalculated and adjusted as necessary.
What's more, during the filling phase, the washing
machine works out the load level and, if necessary,
adjusts the initially displayed program duration
accordingly. During these updates, an animation scrolls
across the duration display.
» to enter the after-sales inquiry mode.
» to page up and the «
29 EN
» to page down.